A crew begins laying pipe in a 6 ft deep trench, and the only ladder is 45 ft from the work face. What is the appropriate correction?
Correct Answer
C) Place safe egress so workers have no more than 25 ft of lateral travel
Provide safe egress within 25 feet of lateral travel under 1926.651(c)(2). The existing 45-foot route is too long. Shield spreaders are not a substitute. Source: https://www.osha.gov/laws-regs/regulations/standardnumber/1926/1926.651
Why This Is the Correct Answer
Provide safe egress within 25 feet of lateral travel under 1926.651(c)(2). The existing 45-foot route is too long. Shield spreaders are not a substitute. Source: https://www.osha.gov/laws-regs/regulations/standardnumber/1926/1926.651
Independent practice; verify any reference hint against the edition and category permitted for your booking. Official exam and reference-list sources →
More NASCLA Questions
A contract permits payment for stored materials only with specified documentation. Which submission supports that payment review?
A tempered glass panel is 5 ft by 9 ft. The supplier weight is 6.5 lb per square foot. What is the panel weight before hardware?
The owner will buy major equipment directly, while the contractor remains responsible for coordination and installation. What must be clarified before the purchase is released?
Which minimum eccentric gravity load and distance does OSHA 1926.755(a)(2) specify for the column anchor-rod assembly during erection?
Using 1 refrigeration ton = 12,000 Btu/h, how many tons of cooling correspond to a scheduled capacity of 180,000 Btu/h?
On the supplied schematic practice drawing (S-741), what is the sum of the three printed chain dimensions? Use the dimension labels rather than scaling the sloping graphic.
Why are backfill lifts limited in thickness?
The specified resilient flooring and adhesive require slab moisture and pH checks before installation. Testing has not been completed, but the crew wants to meet turnover. What should happen?
The approved backfill procedure limits loose lifts to 8 inches for this soil and compactor. A crew places one 24-inch loose lift. What should be done?
Under 2021 IBC 1507.7.2, what is the minimum roof-deck slope for natural slate shingles?
People Also Study
Business & Financial Management
120 questions · 70% to pass
Contract Administration
60 questions · 70% to pass
Project Management
60 questions · 70% to pass
Related Study Resources
Previous Question
Vertical reinforcing is required at 32 in. on center along an 80 ft CMU wall, with a bar at each end. Each bar length including splice projection is 15 ft. What total reinforcing length is needed?
Next Question
Under OSHA 1926.651(g)(1)(i), when must the atmosphere be tested before employees enter an excavation more than 4 feet deep?