A crew checks the stock width of standard gypsum wallboard before loading a lift. Which width is the common full board width?
Correct Answer
B) 48 in.
Standard gypsum wallboard is commonly supplied in a 48 in. width. Other choices describe specialty widths or nonmatching panel dimensions.
Why This Is the Correct Answer
Standard gypsum wallboard is commonly supplied in a 48 in. width. Other choices describe specialty widths or nonmatching panel dimensions.
More NASCLA Questions
Bid instructions require bid security with each sealed bid. Which purpose should the estimator associate with that requirement?
Two addenda revise the drawings before bid day. What must a responsive bidder normally do with those addenda?
An asphalt-shingle roof has a slope of 3:12. Under the IBC low-slope asphalt-shingle provisions, what underlayment arrangement is required?
A rooftop unit schedule lists capacity in tons of cooling. In HVAC estimating, one ton of cooling equals what heat-transfer rate?
The bid form asks for a base bid and three alternates. How should the contractor submit alternate pricing?
A specification includes a $40,000 hardware allowance because final selections are pending. How is the allowance treated in the bid?
The earthwork section requires unit prices for unsuitable-soil removal. What is the contract-administration use of those unit prices?
Before the first progress payment, the owner requests a schedule of values. What is its main contract-payment function?
A signed change order is issued for added lobby millwork. Which contract effect should it state?
On the finish plan, locate room R358; then use the finish schedule. What remarks is listed?
People Also Study
Business & Financial Management
120 questions · 70% to pass
Contract Administration
60 questions · 70% to pass
Project Management
60 questions · 70% to pass
Related Study Resources
Previous Question
On the electrical plan, locate circuit tag C39; then read the panel schedule. What load is shown?
Next Question
A tension lap splice is classified as Class B on the approved reinforcing schedule. How is the required lap length taken from ACI relative to the tension development length ld?