A fire damper is installed above a hard ceiling with no access panel. What should be corrected?
Correct Answer
D) Provide required access for inspection and maintenance
Fire and smoke dampers require access for inspection and maintenance.
Why This Is the Correct Answer
Fire and smoke dampers require access for inspection and maintenance.
Why the Other Options Are Wrong
Option A: Seal the ceiling permanently and leave the damper inaccessible
Choice A gives Seal the ceiling permanently. Its specific error: the option does not produce the required Duct access panel conflict outcome, Provide required access for inspection and maintenance.
Option B: The MEP foreman should remove the damper label
Choice B (Remove the damper label) is rejected because it points to Remove the damper label, but.
Option C: Balance the system without access
In mechanical and plumbing, Balance the system without access is the wrong selection for Duct access panel conflict: it leaves the work at an informal or incomplete stage, while Duct access panel conflict requires Provide required access for inspection and maintenance.
Memory Technique
Tag the scene with duct access panel conflict: wrong actor or wrong timing means the fix is not Provide required access for inspection and maintenance.
Reference Hint
Open Mechanical and Electrical Systems for Construction Managers, 4th Ed., 2024; use by topic index - HVAC capacity / airflow / air changes / TAB to confirm that Fire and smoke dampers require access for inspection and maintenance.
More NASCLA Questions
Bid instructions require bid security with each sealed bid. Which purpose should the estimator associate with that requirement?
A wood deck surface has 320 sf of coverage. Boards have a 5-1/2 in. actual face width, and the order includes an 8 percent cutting allowance. What linear footage is closest?
Using the dimensions shown for the stabilized construction entrance, what is the plan area?
A reroof area requires 14,720 sf of rigid insulation. Boards are 4 ft by 8 ft, and the order includes 5 percent waste. How many boards are needed?
Two addenda revise the drawings before bid day. What must a responsive bidder normally do with those addenda?
A utility trench is 180 ft long, 3 ft wide, and 7 ft deep with vertical sides inside a trench shield. What excavation volume is required?
A 120 ft long Type C trench is cut with a 4 ft bottom width and a 6 ft depth. If side slopes are 1-1/2 horizontal to 1 vertical, what excavation volume is closest?
A storm pipe run needs 240 ft of bedding, 4 ft wide and 6 in. thick. Including a 10 percent ordering allowance, how many cubic yards of bedding aggregate are needed?
A mass excavation produces 1,180 loose cubic yards of material for off-site disposal. End-dump trucks can haul 18 loose cubic yards per trip. What truck count is required?
An asphalt-shingle roof has a slope of 3:12. Under the IBC low-slope asphalt-shingle provisions, what underlayment arrangement is required?
People Also Study
Business & Financial Management
120 questions · 70% to pass
Contract Administration
60 questions · 70% to pass
Project Management
60 questions · 70% to pass