The Bonita Springs site has this projection hazard: anchor rods are uncapped in the walkway. Which safety control is needed?
Correct Answer
C) cap exposed rods
Employees must be protected from impalement or sharp projection hazards in work and access areas.
Why This Is the Correct Answer
Employees must be protected from impalement or sharp projection hazards in work and access areas.
Why the Other Options Are Wrong
Option A: paint the rod tops bright
paint the rod tops bright may relate to another site control, but it does not remove or guard the impalement protection exposure being tested.
Option B: reroute the walkway around
reroute the walkway around may relate to another site control, but it does not remove or guard the impalement protection exposure being tested.
Option D: wrap the rods in tape
wrap the rods in tape may relate to another site control, but it does not remove or guard the impalement protection exposure being tested.
Memory Technique
If Superintendent Corrects can still reach the worker, the control is decoration.
Reference Hint
Open-book path: tab OSHA 29 CFR 1926 to Subpart Q, 1926.701 Concrete and masonry construction; verify the OSHA safety threshold or jobsite control before answering.
More Project Mgmt Questions
The field condition is: the work should be released only if the team addresses that thermal movement must be accommodated. Which coping joint detail best matches the condition?
From the mechanical schedule, what CFM is listed for DOAS-2?
From panel schedule R1, what wire size is shown for circuit R1-5?
A subcontractor asks for direction after noting that the work should be released only if the team addresses that subgrade and aggregate must remain separated. Which geotextile selection best fits the work?
From the specialty item schedule, what height is listed for SP-3?
Using the drawing index, which sheet should you open for the entry wall footing plan?
From the plumbing fixture schedule, what waste size is listed for UR-1?
A Ocala task creates flying-particle exposure because a worker is cutting masonry. Which PPE control is required?
From the light fixture schedule, what mount is listed for L1?
From the loading strip dimension plan, what perimeter length is needed for edge restraint?
People Also Study
Business & Financial Management
120 questions · 70% to pass
Contract Administration
60 questions · 70% to pass