Pulling conductors into a panel without a bushing leaves visible cuts in the insulation at the raceway entry. What is the correct quality response?
Correct Answer
A) Replace the damaged conductors and install proper edge protection before repulling
Damaged insulation at a raceway entry can create faults and must be corrected along with the missing protection that caused it. Other choices conceal the problem or test around the damaged conductors.
Why This Is the Correct Answer
Damaged insulation at a raceway entry can create faults and must be corrected along with the missing protection that caused it. Other choices conceal the problem or test around the damaged conductors.
Why the Other Options Are Wrong
Option B: Tape over the cuts and close the panel
Tape over cut insulation hides the damage but does not restore the conductor or the missing raceway edge protection that caused it.
Option C: Megger only the undamaged phase
Testing only the undamaged phase avoids the actual damaged conductors and does not correct insulation cuts at the entry.
Option D: Leave the conductors because the panel cover hides the damage
A panel cover conceals the damage from view but cannot prevent a fault where insulation has been cut.
Memory Technique
Pair damaged conductor protection with the real field trigger, then choose the response that produces Replace the damaged conductors and install proper edge protection before repulling.
Reference Hint
Open Mechanical and Electrical Systems for Construction Managers, 4th Ed., 2024; use by topic index - conductors / overcurrent / box fill to confirm that Damaged insulation at a raceway entry can create faults and must be corrected along with the missing protection that caused it.
More NASCLA Questions
Bid instructions require bid security with each sealed bid. Which purpose should the estimator associate with that requirement?
A wood deck surface has 320 sf of coverage. Boards have a 5-1/2 in. actual face width, and the order includes an 8 percent cutting allowance. What linear footage is closest?
Using the dimensions shown for the stabilized construction entrance, what is the plan area?
A reroof area requires 14,720 sf of rigid insulation. Boards are 4 ft by 8 ft, and the order includes 5 percent waste. How many boards are needed?
Two addenda revise the drawings before bid day. What must a responsive bidder normally do with those addenda?
A utility trench is 180 ft long, 3 ft wide, and 7 ft deep with vertical sides inside a trench shield. What excavation volume is required?
A 120 ft long Type C trench is cut with a 4 ft bottom width and a 6 ft depth. If side slopes are 1-1/2 horizontal to 1 vertical, what excavation volume is closest?
A storm pipe run needs 240 ft of bedding, 4 ft wide and 6 in. thick. Including a 10 percent ordering allowance, how many cubic yards of bedding aggregate are needed?
A mass excavation produces 1,180 loose cubic yards of material for off-site disposal. End-dump trucks can haul 18 loose cubic yards per trip. What truck count is required?
An asphalt-shingle roof has a slope of 3:12. Under the IBC low-slope asphalt-shingle provisions, what underlayment arrangement is required?
People Also Study
Business & Financial Management
120 questions · 70% to pass
Contract Administration
60 questions · 70% to pass
Project Management
60 questions · 70% to pass