The Hialeah project has this exposure: overhead work is occurring above the crew. Which PPE action should be documented?
Correct Answer
C) head protection enforcement
Head protection is required where falling-object or overhead-impact hazards are present.
Why This Is the Correct Answer
Head protection is required where falling-object or overhead-impact hazards are present.
Why the Other Options Are Wrong
Option A: move the lower crew over
move the lower crew over puts the item in the wrong financial bucket, timing, base, or comparison for head protection.
Option B: bump caps, not hard hats
bump caps, not hard hats puts the item in the wrong financial bucket, timing, base, or comparison for head protection.
Option D: schedule it for later
schedule it for later puts the item in the wrong financial bucket, timing, base, or comparison for head protection.
Memory Technique
Financial Classification ledger for Superintendent Controls: put falling-object in the right drawer.
Reference Hint
Open-book path: tab OSHA 29 CFR 1926 to Subpart E, 1926.100 Head protection; verify the OSHA safety threshold or jobsite control before answering.
More Project Mgmt Questions
The field condition is: the work should be released only if the team addresses that thermal movement must be accommodated. Which coping joint detail best matches the condition?
From the mechanical schedule, what CFM is listed for DOAS-2?
From panel schedule R1, what wire size is shown for circuit R1-5?
A subcontractor asks for direction after noting that the work should be released only if the team addresses that subgrade and aggregate must remain separated. Which geotextile selection best fits the work?
From the specialty item schedule, what height is listed for SP-3?
Using the drawing index, which sheet should you open for the entry wall footing plan?
From the plumbing fixture schedule, what waste size is listed for UR-1?
A Ocala task creates flying-particle exposure because a worker is cutting masonry. Which PPE control is required?
From the light fixture schedule, what mount is listed for L1?
From the loading strip dimension plan, what perimeter length is needed for edge restraint?
People Also Study
Business & Financial Management
120 questions · 70% to pass
Contract Administration
60 questions · 70% to pass
Related Study Resources
Previous Question
The Eustis project has this chemical communication issue: SDS cannot be found for a coating. Which safety control should be completed?
Next Question
At the airport service-court canopy, during the crew-release check, the partition run is 186 ft long and studs are placed at 6 ft on center, including one at the starting end. How many studs are needed?