From the footing takeoff plan, what concrete volume is required for continuous footing F-2?
Correct Answer
B) 12.7 cy
The F-2 footing is 76 ft long, 3 ft wide, and 1.5 ft deep; that equals about 12.7 cubic yards.
Why This Is the Correct Answer
The F-2 footing is 76 ft long, 3 ft wide, and 1.5 ft deep; that equals about 12.7 cubic yards.
Why the Other Options Are Wrong
Option A: 10.1 cy
10.1 cy is below the supported result for concrete footing volume takeoff; it likely omits allowance, conversion, coverage, or final round-up.
Option C: 15.2 cy
15.2 cy is above the supported result for concrete footing volume takeoff; it likely double-counts allowance, uses the wrong unit, or rounds too early.
Option D: 18.6 cy
18.6 cy is above the supported result for concrete footing volume takeoff; it likely double-counts allowance, uses the wrong unit, or rounds too early.
Memory Technique
Placing Verify takeoff: count the condition before counting the package.
Reference Hint
Open-book path: turn to sheet S-101 in the plan packet, then use the FOOTING TAKEOFF PLAN note/table before checking P&P Commercial Construction plan-reading guidance.
More Project Mgmt Questions
The field condition is: the work should be released only if the team addresses that thermal movement must be accommodated. Which coping joint detail best matches the condition?
From the mechanical schedule, what CFM is listed for DOAS-2?
From panel schedule R1, what wire size is shown for circuit R1-5?
A subcontractor asks for direction after noting that the work should be released only if the team addresses that subgrade and aggregate must remain separated. Which geotextile selection best fits the work?
From the specialty item schedule, what height is listed for SP-3?
Using the drawing index, which sheet should you open for the entry wall footing plan?
From the plumbing fixture schedule, what waste size is listed for UR-1?
A Ocala task creates flying-particle exposure because a worker is cutting masonry. Which PPE control is required?
From the light fixture schedule, what mount is listed for L1?
From the loading strip dimension plan, what perimeter length is needed for edge restraint?
People Also Study
Business & Financial Management
120 questions · 70% to pass
Contract Administration
60 questions · 70% to pass