Which of the following describes the primary purpose of Michigan's Energy Code requirements for residential construction?
Correct Answer
A) To minimize energy consumption and improve building envelope performance
Michigan Energy Code is designed to minimize energy consumption, improve building envelope performance, and reduce environmental impact through energy-efficient construction practices.
Why This Is the Correct Answer
The primary purpose of Michigan's Energy Code is to minimize energy consumption and improve building envelope performance. The code sets standards for insulation, windows, air sealing, and mechanical systems to reduce heating and cooling loads in residential buildings.
Why the Other Options Are Wrong
Option B: To ensure structural integrity during severe weather events
Structural integrity during severe weather is governed by the Michigan Building Code (structural provisions), not the Energy Code. The Energy Code focuses on thermal performance, not load-bearing capacity.
Option C: To reduce construction costs through standardized materials
The Energy Code does not aim to reduce construction costs through material standardization. In fact, meeting higher energy requirements often increases initial costs, though it saves money over the building's lifetime through reduced utility bills.
Option D: To establish uniform architectural standards across the state
Uniform architectural standards are not within the scope of the Energy Code. Aesthetic and architectural standards are addressed by local zoning ordinances and design guidelines, not energy codes.
Memory Technique
Energy Code = Energy Savings. The word 'energy' in the name directly tells you the purpose — it's all about reducing energy use in buildings.
More Michigan Questions
A residential foundation wall in Michigan is 8 feet high with 2 feet above grade. The backfill exerts lateral pressure of 30 psf per foot of depth. What is the maximum lateral pressure at the bottom of the foundation wall?
A builder discovers that the electrical service entrance was installed without proper permits. According to Michigan law, what is the most appropriate next step?
What is the maximum allowable span for a 2x8 floor joist (Grade 2 Douglas Fir) at 16" O.C. with 40 psf live load and 10 psf dead load according to Michigan Building Code span tables?
According to Michigan Building Code, what is the maximum height of a wood-framed bearing wall using 2x4 studs with standard construction?
A homeowner requests to convert a bedroom into a bathroom on the second floor. What is the primary Michigan code concern the builder must address?
According to Michigan plumbing regulations, what is the minimum pipe size required for a water service line serving a single-family residence?
A contractor is building a basement foundation wall that is 8 feet high and will retain 6 feet of soil. What is the minimum wall thickness required by the Michigan Building Code for poured concrete?
A homeowner wants to install a gas fireplace in their living room. The contractor notices the existing gas line is 1/2 inch black iron pipe. For a 40,000 BTU fireplace with a 25-foot run, is this pipe size adequate according to Michigan gas code?
During a framing inspection, the building official notes that the contractor used 2x4 studs at 24 inches on center for an exterior wall. According to Michigan Building Code, what is the maximum wall height allowed for this configuration?
A contractor is installing a beam to support floor joists. The beam must carry a total load of 8,000 pounds over a 12-foot span. If the allowable fiber stress for the lumber grade is 1,200 psi, what is the minimum required section modulus?
People Also Study
Business & Financial Management
120 questions · 70% to pass
Contract Administration
60 questions · 70% to pass
Project Management
60 questions · 70% to pass
Related Study Resources
Previous Question
Under Michigan's Energy Code, what is the minimum R-value requirement for wall insulation in Climate Zone 6A?
Next Question
A residential plumbing rough-in requires a 3-inch drain pipe to be installed with a 2% slope. If the horizontal run is 25 feet, what is the total vertical drop required?