EstatePass
mi-builderMichigan Residential Buildereasy

According to Michigan plumbing regulations, what is the minimum pipe size required for a water service line serving a single-family residence?

Correct Answer

D) 3/4 inch

Michigan plumbing code requires a minimum 3/4 inch water service line for single-family residences to ensure adequate water pressure and flow.

Answer Options
A
1 inch
B
1-1/4 inch
C
1/2 inch
D
3/4 inch

Why This Is the Correct Answer

According to Michigan plumbing regulations, a 3/4 inch water service line is the minimum required size for single-family residential properties. This diameter ensures adequate water pressure and flow rate to meet typical household demands including multiple fixtures operating simultaneously. The 3/4 inch requirement balances cost-effectiveness with performance, providing sufficient capacity for standard residential water usage while maintaining proper pressure throughout the home's plumbing system.

Why the Other Options Are Wrong

Option A: 1 inch

A 1 inch water service line exceeds the minimum requirement and would be unnecessarily large for most single-family residences. While it would provide excellent flow and pressure, it represents overbuilding and increased material costs without significant benefit for typical residential applications.

Option B: 1-1/4 inch

A 1-1/4 inch water service line is significantly oversized for single-family residential use and exceeds Michigan's minimum requirements. This size would typically be used for larger buildings or commercial applications where much higher flow rates are needed.

Option C: 1/2 inch

A 1/2 inch water service line is too small for single-family residential applications and falls below Michigan's minimum requirements. This size would result in inadequate water pressure and flow, especially when multiple fixtures are used simultaneously, creating poor performance and potential code violations.

Memory Technique

Remember '3/4 for the door' - three-quarters inch gets water through your front door and serves your home adequately.

Was this explanation helpful?

More mi-builder Questions

A residential foundation wall in Michigan is 8 feet high with 2 feet above grade. The backfill exerts lateral pressure of 30 psf per foot of depth. What is the maximum lateral pressure at the bottom of the foundation wall?

A builder discovers that the electrical service entrance was installed without proper permits. According to Michigan law, what is the most appropriate next step?

What is the maximum allowable span for a 2x8 floor joist (Grade 2 Douglas Fir) at 16" O.C. with 40 psf live load and 10 psf dead load according to Michigan Building Code span tables?

According to Michigan Building Code, what is the maximum height of a wood-framed bearing wall using 2x4 studs with standard construction?

A homeowner requests to convert a bedroom into a bathroom on the second floor. What is the primary Michigan code concern the builder must address?

A contractor is building a basement foundation wall that is 8 feet high and will retain 6 feet of soil. What is the minimum wall thickness required by the Michigan Building Code for poured concrete?

A homeowner wants to install a gas fireplace in their living room. The contractor notices the existing gas line is 1/2 inch black iron pipe. For a 40,000 BTU fireplace with a 25-foot run, is this pipe size adequate according to Michigan gas code?

During a framing inspection, the building official notes that the contractor used 2x4 studs at 24 inches on center for an exterior wall. According to Michigan Building Code, what is the maximum wall height allowed for this configuration?

A contractor is installing a beam to support floor joists. The beam must carry a total load of 8,000 pounds over a 12-foot span. If the allowable fiber stress for the lumber grade is 1,200 psi, what is the minimum required section modulus?

Under Michigan residential construction standards, what is the minimum ceiling height required for habitable rooms?

People Also Study

Related Study Resources

Practice More Contractor Exam Questions

Access all practice questions with progress tracking and adaptive difficulty to pass your Florida General Contractor exam.

Start Practicing

Disclaimer: EstatePass is an independent exam preparation platform and is not affiliated with, endorsed by, or connected to any state contractor licensing board, the Construction Industry Licensing Board (CILB), the Department of Business and Professional Regulation (DBPR), NASCLA, Pearson VUE, PSI, or any government agency. Exam requirements, fees, and regulations change frequently. Always verify current requirements with your state's licensing board before making decisions. Information shown was last verified on the dates indicated and may not reflect the most recent changes.