During which phase of construction is the electrical rough-in inspection typically scheduled?
Correct Answer
B) After framing but before insulation and drywall
Electrical rough-in inspection occurs after framing is complete but before insulation and drywall installation. This allows inspectors to see all electrical work that will be concealed by finishing materials.
Why This Is the Correct Answer
Electrical rough-in inspection must occur after framing is complete because the electrical wiring runs through the framed walls and structure. However, it must happen before insulation and drywall installation because once these materials are installed, the electrical work becomes concealed and cannot be properly inspected. This timing allows inspectors to verify proper wire routing, box placement, grounding, and code compliance while everything is still visible and accessible.
Why the Other Options Are Wrong
Option A: After drywall installation
Before framing inspection is too early because electrical rough-in work cannot be properly installed until the framing is complete - the wires need the framed structure to run through walls, floors, and ceilings.
Option C: Before framing inspection
At final inspection only is incorrect because electrical rough-in work would be completely concealed by that point, and any defects discovered would require costly demolition of finished surfaces to correct.
Option D: At final inspection only
After drywall installation is too late because the electrical work would already be concealed behind the finished wall surfaces, making it impossible for inspectors to verify proper installation, wire routing, and code compliance.
Memory Technique
Think 'FRAME then WIRE then HIDE' - Frame first, then Wire (and inspect), then Hide with insulation and drywall.
Reference Hint
Florida Building Code, Chapter 1, Section 110 - Electrical Inspections, or the electrical section of your contractor reference manual covering inspection scheduling
More Contract Admin Questions
A project experiences a 30-day delay due to unusually severe weather. The contract includes a liquidated damages clause of $1,000 per day for delays. If the weather delay is excusable but not compensable, what liquidated damages apply?
A commercial project requires a total of 12 inspections. The building department charges $85 per inspection for the first 5 inspections, $65 for inspections 6-10, and $45 for any additional inspections. What is the total inspection fee?
What document must be posted at the job site before a Certificate of Occupancy can be issued for a commercial building?
A mixed-use development requires a variance for reduced setbacks. The property is located within 500 feet of a hospital. What additional consideration must be addressed?
A LEED project requires tracking of regional materials. Materials are considered regional if they are extracted, harvested, or recovered, as well as manufactured within what distance of the project site?
An indemnification clause in a construction contract typically requires the contractor to:
A property owner wants to convert a single-family home into a duplex in an area zoned for single-family residential use. The conversion meets all building codes but violates density requirements. What approval is needed?
As-built drawings are typically required to be submitted:
AIA Document A401 is primarily used for:
A general contractor is building a 12,000 square foot commercial warehouse. The building permit fee is calculated at $8.50 per $1,000 of construction value. If the project value is $2,400,000, what is the building permit fee?
People Also Study
Business & Financial Management
120 questions · 70% to pass
Project Management
60 questions · 70% to pass
Related Study Resources
Previous Question
A roofing crew's productivity rate is 25 squares per day in good weather but drops to 18 squares per day in adverse conditions. For a 450-square roof project scheduled during hurricane season, what is the estimated duration accounting for weather delays?
Next Question
A quality control inspection reveals that concrete strength tests show 2,800 psi when the specification requires 3,000 psi. What should be the first step in the quality control procedure?