Which single certification lets a technician service both an R-11 centrifugal chiller and the building's R-410A rooftop units?
Correct Answer
D) Universal certification
Certification is granted by type, and each type covers a defined slice of equipment. Type III covers low-pressure appliances such as the R-11 centrifugal machine, while Type II covers high-pressure appliances such as R-410A rooftop units. A technician who passes the core section plus all three type sections earns Universal certification, which covers every category. Holding only one type limits the technician to that category, so a mixed plant either needs a Universal card or a crew whose individual cards together cover the equipment.
Why This Is the Correct Answer
Universal certification is earned by passing the core section and all three type sections, and it authorizes work on small appliances, high-pressure appliances and low-pressure appliances alike. In a plant that mixes an R-11 chiller with R-410A rooftop equipment, that is the one card that covers every machine the technician will touch.
Why the Other Options Are Wrong
Option A: Type III certification held alone
Type III alone covers the low-pressure chiller but gives no authority over the high-pressure rooftop equipment. A technician holding it alone would have to turn down every rooftop call in the building.
Option B: Type I certification
Type I covers only small factory sealed appliances charged with five pounds or less. It authorizes work on neither the chiller nor the rooftop units.
Option C: Type II certification held alone
Type II alone covers the high-pressure rooftop units but stops at the low-pressure chiller, which requires Type III. Holding it alone leaves the technician unable to open the machine that needs the most attention.
Memory Technique
One, two, three, all. Universal is just the whole set of type cards in one.
Reference Hint
Type I covers small appliances, Type II high-pressure, Type III low-pressure, and Universal covers all three.
More epa-608-type-3 Questions
Some jobs on a chiller count as a major repair under the refrigerant rules, which changes what a technician is allowed to do with a badly leaking machine. Which job falls into that category?
An owner asks how many pounds of refrigerant the rules allow to be left inside a chiller once the recovery has been signed off. What is the correct answer to give him?
The motor of a hermetic centrifugal chiller sits inside the pressure boundary rather than outside it on a shaft. What follows from that construction?
An oxygen monitor is used to decide whether a chiller machine room is safe to enter after a refrigerant release. Below what oxygen reading is the atmosphere treated as oxygen deficient?
A low-pressure chiller's rupture disc has a discharge line running from it. Where does that line have to terminate?
A refrigerant vapor detector in a chiller machine room reaches its alarm level. Besides sounding, what is that alarm expected to do?
Which piece of equipment requires a technician to hold Type III certification before it may be serviced?
What property of the refrigerant is what actually places an appliance into the low-pressure category?
During normal operation, what condition exists inside the evaporator of a running low-pressure centrifugal chiller?
In what unit is the required final recovery vacuum for a low-pressure appliance normally expressed?
People Also Study
Business & Financial Management
120 questions · 70% to pass
Contract Administration
60 questions · 70% to pass
Project Management
60 questions · 70% to pass