Upper cabinets are fastened into drywall where no blocking or studs are found at the planned locations. What should be corrected?
Correct Answer
B) Attachment backing.
Wall cabinets need fasteners into adequate framing, blocking, or approved backing.
Why This Is the Correct Answer
Wall cabinets need fasteners into adequate framing, blocking, or approved backing.
Why the Other Options Are Wrong
Option A: Proceed with the finish work where upper cabinets are fastened into drywall, and address only the visible finish at the end.
Proceed with the finish work where upper cabinets are fastened into drywall, and address only the visible finish at the end. does not satisfy the required party, deadline, proof, license, bond, insurance, or agency trigger for cabinet anchorage.
Option C: Treat the item as a color or trim preference where upper cabinets are fastened into drywall, instead of verifying the required finish detail first.
Treat the item as a color or trim preference where upper cabinets are fastened into drywall, instead of verifying the required finish detail first. does not satisfy the required party, deadline, proof, license, bond, insurance, or agency trigger for cabinet anchorage.
Option D: Accept the installer's shortcut where upper cabinets are fastened into drywall, without confirming the finish detail before acceptance.
Accept the installer's shortcut where upper cabinets are fastened into drywall, without confirming the finish detail before acceptance. does not satisfy the required party, deadline, proof, license, bond, insurance, or agency trigger for cabinet anchorage.
Memory Technique
Cabinet Anchorage clock for Checking Installation: party, date, proof, then rights.
Reference Hint
Study anchor (closed-book): memorize Cabinet anchorage from CSLB B General Building Study Guide; California Building Code, Title. / CSLB B General Building Study Guide cabinet installation support; know the rule or calculation trigger without relying on exam-room lookup.
More Class B Trade Questions
A 2-inch horizontal sanitary branch must be installed at 1/4 inch fall per foot. What total fall is needed over a 24-foot run?
A 4-inch building drain is laid out with a required 1/8 inch fall per foot. What fall is required across 40 feet?
A rooftop unit schedule shows 3 tons of cooling. Using 12,000 Btu per hour per ton, what cooling capacity is this?
A pump motor is listed as 2 horsepower, and the coordination table asks for watts. Using 746 watts per horsepower, what is the approximate motor power?
A slab is 30 feet long, 18 feet wide, and 4 inches thick. How many cubic yards of concrete are needed before waste?
A footing is 80 feet long, 2 feet wide, and 12 inches deep. How many cubic yards of concrete are required before waste?
A patio subgrade must drain at 2 percent away from the building for 20 feet. What total drop is required?
A building pad needs 150 compacted cubic yards of fill. If the borrow material shrinks 10 percent after compaction, about how many loose cubic yards should be hauled in?
A roofing estimate shows 2,850 square feet of roof area. How many roofing squares is that?
A waterproof deck surface is 14 feet deep and must slope 1/4 inch per foot to the drain. What vertical fall is needed?