A worker on your job site has been assigned to operate a jackhammer for concrete demolition. Which PPE is NOT specifically required by OSHA for this task?
Correct Answer
D) Cut-resistant gloves
While cut-resistant gloves may be beneficial, they are not specifically required by OSHA for jackhammer operation. Eye protection, hearing protection, and foot protection are mandated.
Why This Is the Correct Answer
Cut-resistant gloves are not specifically mandated by OSHA for jackhammer operation. While they may provide additional protection against abrasions, OSHA's specific requirements for jackhammer work focus on protection from the primary hazards: flying debris (eye protection), noise exposure (hearing protection), and falling objects or equipment contact with feet (steel-toed boots). Cut-resistant gloves fall under general hand protection recommendations rather than specific OSHA requirements for this task.
Why the Other Options Are Wrong
Option A: Safety glasses or goggles
Safety glasses or goggles are specifically required by OSHA for jackhammer operation due to the high risk of flying concrete debris and dust that can cause serious eye injuries.
Option B: Hearing protection
Hearing protection is specifically required by OSHA for jackhammer operation because jackhammers typically produce noise levels exceeding 85 decibels, which can cause permanent hearing damage.
Memory Technique
Use the acronym 'SEF' for jackhammer PPE: Safety glasses (eyes), Ear protection (hearing), Foot protection (steel-toed boots). Notice 'H' for hands/gloves is missing from the required list.
Reference Hint
OSHA Construction Standards 29 CFR 1926 Subpart E - Personal Protective and Life Saving Equipment, specifically sections on eye/face protection (1926.95), hearing protection (1926.95), and foot protection (1926.96)
More Project Mgmt Questions
What is the minimum R-value required for wall insulation in Florida Climate Zone 2?
A subcontractor brings a new chemical product to your jobsite. Under the Globally Harmonized System (GHS), what information must be immediately available to workers?
A construction site has a trench that is 8 feet deep in Type B soil. What is the maximum allowable slope ratio for the trench walls without protective systems?
What is the maximum recommended spacing between drywall screws when attaching to wood studs?
Your crew discovers suspected asbestos-containing materials during a renovation project. What is the first action you should take?
A scaffold platform is 12 feet long and 5 feet wide. If the maximum load capacity is 25 pounds per square foot, what is the total weight capacity of this platform?
Which CSI MasterFormat Division would contain specifications for fire-stopping and firesafing materials?
In tilt-up concrete construction, what is the primary advantage of this method over conventional cast-in-place construction?
Which OSHA standard specifically addresses construction industry safety and health regulations?
A structural drawing shows a beam labeled 'W12x26'. What does the '26' represent?
People Also Study
Business & Financial Management
120 questions · 70% to pass
Contract Administration
60 questions · 70% to pass
Related Study Resources
Previous Question
How many cubic yards of concrete are needed for a foundation wall that is 100 feet long, 8 inches thick, and 4 feet high?
Next Question
A section drawing is cut through a building at line "A-A" as shown on the floor plan. The section shows a foundation wall that extends 3 feet below grade. If the floor elevation is 100.5 feet, what is the elevation at the bottom of the foundation?