A technician holding Core and Type II wants to know what a Universal certification card would let him do that his current credentials do not already allow. What does Universal add?
Correct Answer
B) It allows work on small appliances and low-pressure appliances in addition to the high-pressure equipment already covered
Universal is not a separate exam. It is what a technician holds after passing Core plus all three type exams. For someone who already has Core and Type II, adding Type I and Type III opens up factory-sealed small appliances and low-pressure machines such as R-123 centrifugal chillers. It does not relax any equipment, evacuation or recordkeeping requirement, and it does not reach motor vehicle air conditioning, which is covered by a separate certification program under a different section of the law.
Why This Is the Correct Answer
Universal simply means every type exam has been passed. The practical gain for a Type II holder is access to the two equipment classes he is currently locked out of: small appliances on the Type I side and low-pressure appliances on the Type III side. The technical rules for each class stay exactly the same.
Why the Other Options Are Wrong
Option A: It removes the requirement to use certified recovery equipment on high-pressure jobs, since all three type exams have been passed
Certified recovery equipment is required no matter which card a technician carries. Certification levels describe what equipment a person may work on, and none of them exempt anyone from using approved machines.
Option C: It extends the certification to motor vehicle air conditioning work on cars, trucks and buses
Motor vehicle air conditioning is covered by a separate certification program under a different section of the law. Passing all three Section 608 type exams does not authorize work on a car or truck system.
Option D: It shortens the evacuation level required before a large commercial system may be opened for service
Required evacuation levels are set by the appliance and its charge, not by the technician's credentials. A higher certification never shortens or relaxes a procedure the rule specifies.
Memory Technique
Universal is a bigger key ring, not a skeleton key - more doors, same locks on each one.
Reference Hint
40 CFR 82.161: Universal certification is granted to technicians who pass Core plus Type I, Type II and Type III. Certification does not expire.
More epa-608-type-2 Questions
A walk-in cooler condensing unit holds a full charge of twenty-five pounds of R-404A, which is below the fifty pound threshold that brings an appliance under the leak repair provisions. What still applies to this unit?
An office building has thirty water source heat pumps on a common water loop, and each one left the factory assembled, hermetically sealed and charged with four pounds of R-410A. How is one of those units classified?
A data sheet for an unfamiliar refrigerant lists a boiling point of about fifty-five degrees Fahrenheit at atmospheric pressure. What does that tell a technician holding Core and Type II certification?
A technician holds Core, Type I and Type III certification and is sent to recover the charge from a twenty ton rooftop unit charged with R-410A. What does that combination of sections allow on this job?
A fleet garage technician holds only the vehicle air conditioning certification issued under Section 609 and is asked to recover the charge from the shop's own rooftop air conditioner. What does that credential allow?
A split system's outdoor unit, indoor coil and the line set the installer ran and brazed between them are being considered. For the purposes of the refrigerant rules, what makes up the appliance here?
On a new installation the line set is brazed to a factory charged outdoor unit and an indoor coil shipped under a nitrogen holding charge, with the outdoor unit's service valves still closed. What does the recovery requirement call for before that brazing?
A rooftop unit's data plate has weathered until the charge figure cannot be read, and the technician needs the full charge to place the appliance under the evacuation and leak provisions. Where should that figure come from?
A computer room air conditioning unit holds forty pounds of R-407C and connects to a remote air cooled condenser through refrigerant piping run and brazed by the installer. How is that unit classified?
A shop's office manager, who holds no technician certification, is sent to a supply house to pick up a new recovery machine for the commercial crew. What does the sales restriction require at that counter?
People Also Study
Business & Financial Management
120 questions · 70% to pass
Contract Administration
60 questions · 70% to pass
Project Management
60 questions · 70% to pass
Related Study Resources
Previous Question
A brazed joint made without flowing nitrogen through the tubing develops a pinhole leak after a season of operation, and the system also shows a restricted metering device. What did the missing nitrogen contribute to?
Next Question
A split system's outdoor unit, indoor coil and the line set the installer ran and brazed between them are being considered. For the purposes of the refrigerant rules, what makes up the appliance here?