The finish-floor worksheet shows that the finish-floor takeoff measures 18 feet by 16 feet, with material priced at $5.25 per square foot. What pre-waste material cost is estimated?
Correct Answer
A) $1,512.
The floor area is 18 x 16 = 288 square feet. At $5.25 per square foot, the material cost is $1,512.
Why This Is the Correct Answer
The floor area is 18 x 16 = 288 square feet. At $5.25 per square foot, the material cost is $1,512.
Why the Other Options Are Wrong
Option B: $1,440 total.
$1,440 total. is below the supported result for flooring cost calculation; it likely omits allowance, conversion, coverage, or final round-up.
Option C: $1,548 total.
$1,548 total. is above the supported result for flooring cost calculation; it likely double-counts allowance, uses the wrong unit, or rounds too early.
Option D: $1,620 total.
$1,620 total. is above the supported result for flooring cost calculation; it likely double-counts allowance, uses the wrong unit, or rounds too early.
Memory Technique
Measure to floor, adjust for area, then let Estimating Material set the finish line.
Reference Hint
Study anchor (closed-book): memorize Flooring cost calculation from CSLB B General Building Study Guide; California Building Code, Title. / CSLB B General Building Study Guide flooring estimating; know the rule or calculation trigger without relying on exam-room lookup.
More Class B Trade Questions
A 2-inch horizontal sanitary branch must be installed at 1/4 inch fall per foot. What total fall is needed over a 24-foot run?
A 4-inch building drain is laid out with a required 1/8 inch fall per foot. What fall is required across 40 feet?
A rooftop unit schedule shows 3 tons of cooling. Using 12,000 Btu per hour per ton, what cooling capacity is this?
A pump motor is listed as 2 horsepower, and the coordination table asks for watts. Using 746 watts per horsepower, what is the approximate motor power?
A slab is 30 feet long, 18 feet wide, and 4 inches thick. How many cubic yards of concrete are needed before waste?
A footing is 80 feet long, 2 feet wide, and 12 inches deep. How many cubic yards of concrete are required before waste?
A patio subgrade must drain at 2 percent away from the building for 20 feet. What total drop is required?
A building pad needs 150 compacted cubic yards of fill. If the borrow material shrinks 10 percent after compaction, about how many loose cubic yards should be hauled in?
A roofing estimate shows 2,850 square feet of roof area. How many roofing squares is that?
A waterproof deck surface is 14 feet deep and must slope 1/4 inch per foot to the drain. What vertical fall is needed?