What does the plumbing symbol 'CO' typically represent on mechanical drawings?
Correct Answer
A) Cleanout
In plumbing drawings, 'CO' stands for cleanout, which is an access point in the drainage system for maintenance and clearing blockages. Cold water is typically abbreviated as 'CW'.
Why This Is the Correct Answer
The plumbing symbol 'CO' universally represents cleanout in mechanical and plumbing drawings. Cleanouts are essential access points strategically placed in drainage systems to allow maintenance personnel to clear blockages and perform routine cleaning. These access points are critical for proper system maintenance and are required by plumbing codes at specific intervals and locations throughout the drainage system. Understanding this symbol is fundamental for reading plumbing plans correctly.
Why the Other Options Are Wrong
Option B: Cold water
Carbon monoxide detectors are usually shown with specific symbols or abbreviated as 'CMD' or 'CO DETECTOR' to avoid confusion with plumbing cleanouts. The 'CO' abbreviation in plumbing context specifically refers to cleanouts.
Option C: Condensate
Condensate lines are typically abbreviated as 'CD' or 'COND' on mechanical drawings, not 'CO'. Condensate refers to water that forms from air conditioning systems or other equipment.
Option D: Carbon monoxide detector
Cold water is abbreviated as 'CW' in plumbing drawings, not 'CO'. This is a standard convention used across all mechanical drawings to distinguish between different water supply lines.
Memory Technique
Think 'CO = Clean Out' - both words start with 'C' and 'O'. Visualize a worker cleaning out a drain through an access point marked 'CO' on the drawing.
Reference Hint
Florida Building Code - Plumbing, Chapter 7 (Sanitary Drainage) or mechanical drawing symbol reference charts in plumbing code books
More Project Mgmt Questions
What is the minimum R-value required for wall insulation in Florida Climate Zone 2?
A subcontractor brings a new chemical product to your jobsite. Under the Globally Harmonized System (GHS), what information must be immediately available to workers?
A construction site has a trench that is 8 feet deep in Type B soil. What is the maximum allowable slope ratio for the trench walls without protective systems?
What is the maximum recommended spacing between drywall screws when attaching to wood studs?
Your crew discovers suspected asbestos-containing materials during a renovation project. What is the first action you should take?
A scaffold platform is 12 feet long and 5 feet wide. If the maximum load capacity is 25 pounds per square foot, what is the total weight capacity of this platform?
Which CSI MasterFormat Division would contain specifications for fire-stopping and firesafing materials?
In tilt-up concrete construction, what is the primary advantage of this method over conventional cast-in-place construction?
Which OSHA standard specifically addresses construction industry safety and health regulations?
A structural drawing shows a beam labeled 'W12x26'. What does the '26' represent?
People Also Study
Business & Financial Management
120 questions · 70% to pass
Contract Administration
60 questions · 70% to pass