Under the CSI MasterFormat system, which division covers concrete work?
Correct Answer
D) Division 03
Division 03 in the CSI MasterFormat covers concrete work, including cast-in-place concrete, precast concrete, and concrete accessories. This is part of the standardized specification organization system.
Why This Is the Correct Answer
Division 03 in the CSI MasterFormat system specifically covers all concrete work including cast-in-place concrete, precast concrete, concrete accessories, concrete reinforcement, and concrete restoration. This division is universally recognized in the construction industry and is essential knowledge for contractors who must read and interpret construction specifications. Understanding this division helps contractors properly organize project specifications and coordinate concrete-related work activities.
Why the Other Options Are Wrong
Option B: Division 04
Division 06 covers wood, plastics, and composites including rough carpentry, finish carpentry, architectural woodwork, and plastic fabrications. This division is completely unrelated to concrete work and focuses on organic and synthetic building materials rather than cementitious materials.
Option C: Division 05
Division 04 covers masonry work, not concrete. This division includes brick, block, stone, mortar, grout, and masonry accessories. While masonry and concrete are both structural materials, they are distinctly different construction systems with separate specification requirements and installation methods.
Memory Technique
Remember '03 = Concrete' by thinking 'Zero-Three Concrete' - the zero looks like a concrete pipe and three sounds like 'tree' (concrete grows strong like a tree trunk).
More Project Mgmt Questions
What is the minimum R-value required for wall insulation in Florida Climate Zone 2?
A subcontractor brings a new chemical product to your jobsite. Under the Globally Harmonized System (GHS), what information must be immediately available to workers?
A construction site has a trench that is 8 feet deep in Type B soil. What is the maximum allowable slope ratio for the trench walls without protective systems?
What is the maximum recommended spacing between drywall screws when attaching to wood studs?
Your crew discovers suspected asbestos-containing materials during a renovation project. What is the first action you should take?
A scaffold platform is 12 feet long and 5 feet wide. If the maximum load capacity is 25 pounds per square foot, what is the total weight capacity of this platform?
Which CSI MasterFormat Division would contain specifications for fire-stopping and firesafing materials?
In tilt-up concrete construction, what is the primary advantage of this method over conventional cast-in-place construction?
Which OSHA standard specifically addresses construction industry safety and health regulations?
A structural drawing shows a beam labeled 'W12x26'. What does the '26' represent?
People Also Study
Business & Financial Management
120 questions · 70% to pass
Contract Administration
60 questions · 70% to pass
Related Study Resources
Previous Question
A soil compaction test shows 92% of maximum density. The specification requires 95% compaction. What volume of additional compactive effort is needed if the test area is 1,000 square feet at 8 inches thick?
Next Question
On a construction project, the architect has rejected a shop drawing submittal. What should the contractor do next?