In California seismic design categories D, E, and F, what is the required connection method for attaching the sill plate to the foundation in wood frame construction?
Correct Answer
A) 1/2-inch diameter anchor bolts at 6 feet on center maximum
Per CRC Section R403.1.6 and California amendments, sill plates in seismic design categories D, E, and F require minimum 1/2-inch diameter anchor bolts spaced maximum 6 feet on center, with specific embedment and edge distance requirements for seismic resistance.
Why This Is the Correct Answer
Per CRC Section R403.1.6 and California amendments, sill plates in seismic design categories D, E, and F require minimum 1/2-inch diameter anchor bolts spaced maximum 6 feet on center, with specific embedment and edge distance requirements for seismic resistance.
More trade-general-building Questions
When installing engineered lumber joists (I-joists) in California residential construction, what is the primary code requirement for web stiffeners?
What is the required attic ventilation ratio when a vapor retarder is installed on the warm-in-winter side of the ceiling according to the California Residential Code?
In California's Wildland-Urban Interface (WUI) areas, which underlayment requirement applies to Class A fire-rated roof assemblies?
In California, when installing a tankless water heater in a seismic zone, what additional requirement must be met beyond standard installation practices?
According to the California Building Code (CBC), what is the minimum lap splice length for #4 rebar in a concrete foundation wall in normal weight concrete with f'c = 3000 psi?
According to CBC requirements for retaining walls in California, what additional design consideration must be addressed for retaining walls over 4 feet in height located in seismic design categories D, E, and F?
When constructing retaining walls in California that exceed 4 feet in height, which CBC requirement must be met regarding drainage?
Under California regulations, when is a reduced pressure principle (RPP) backflow prevention assembly required for a residential water service connection?
Under California Title 24, what is the minimum electrical service size required for new single-family residential construction?
According to the California Building Code, buildings located in Seismic Design Category D must comply with which specific seismic design requirements?
People Also Study
Business & Financial Management
120 questions · 70% to pass
Contract Administration
60 questions · 70% to pass
Project Management
60 questions · 70% to pass
Related Study Resources
Previous Question
What is the required attic ventilation ratio when a Class I or II vapor retarder is installed on the warm side of the ceiling according to the CRC?
Next Question
According to California Building Code requirements for post-tensioned concrete slabs on grade, what is the minimum slab thickness required when the post-tensioning system is designed to resist all shrinkage and temperature stresses?