A quality control inspection reveals that concrete strength test results show 2,800 psi when 3,000 psi was specified. What should be the immediate next step?
Correct Answer
D) Notify the engineer and request structural analysis
When concrete strength tests fail to meet specifications, the structural engineer must be notified to perform an analysis and determine if the reduced strength is acceptable or if remedial action is required. This ensures structural integrity is maintained.
Why This Is the Correct Answer
When concrete strength tests fail to meet specifications, the structural engineer must be notified immediately to perform a structural analysis. The engineer will determine if the reduced strength compromises structural integrity and what remedial actions are necessary. This is the proper protocol to ensure safety and compliance with building codes. Only the engineer can make the determination about whether the concrete is structurally adequate or needs replacement.
Why the Other Options Are Wrong
Option B: Accept the concrete since it's close to specification
Immediate removal and replacement is premature and potentially unnecessary. The engineer must first analyze whether the reduced strength is structurally acceptable before deciding on such drastic and expensive action.
Option C: Remove and replace all affected concrete immediately
Accepting concrete that doesn't meet specifications is a serious code violation and safety risk. A 200 psi difference (6.7% below spec) could compromise structural integrity and is not acceptable without engineering analysis.
Memory Technique
Think 'ENGINEER FIRST' - when concrete strength fails, the Engineer must analyze First before any other action is taken.
Reference Hint
Florida Building Code, Chapter 19 - Concrete, Section on Quality Control and Testing Requirements
More Contract Admin Questions
A project experiences a 30-day delay due to unusually severe weather. The contract includes a liquidated damages clause of $1,000 per day for delays. If the weather delay is excusable but not compensable, what liquidated damages apply?
A commercial project requires a total of 12 inspections. The building department charges $85 per inspection for the first 5 inspections, $65 for inspections 6-10, and $45 for any additional inspections. What is the total inspection fee?
What document must be posted at the job site before a Certificate of Occupancy can be issued for a commercial building?
A mixed-use development requires a variance for reduced setbacks. The property is located within 500 feet of a hospital. What additional consideration must be addressed?
A LEED project requires tracking of regional materials. Materials are considered regional if they are extracted, harvested, or recovered, as well as manufactured within what distance of the project site?
An indemnification clause in a construction contract typically requires the contractor to:
A property owner wants to convert a single-family home into a duplex in an area zoned for single-family residential use. The conversion meets all building codes but violates density requirements. What approval is needed?
As-built drawings are typically required to be submitted:
AIA Document A401 is primarily used for:
A general contractor is building a 12,000 square foot commercial warehouse. The building permit fee is calculated at $8.50 per $1,000 of construction value. If the project value is $2,400,000, what is the building permit fee?
People Also Study
Business & Financial Management
120 questions · 70% to pass
Project Management
60 questions · 70% to pass