On a mechanical drawing, what does the abbreviation 'CFM' represent?
Correct Answer
A) Cubic feet per minute
CFM stands for cubic feet per minute, which is the standard unit of measurement for airflow in HVAC systems. This measurement is critical for proper system sizing and performance.
Why This Is the Correct Answer
CFM stands for cubic feet per minute, which is the universally accepted unit of measurement for volumetric airflow in HVAC systems. This measurement indicates how many cubic feet of air move through a system in one minute. It's essential for determining proper ventilation rates, equipment sizing, and ensuring adequate air circulation in buildings. General contractors must understand this term as it appears frequently on mechanical drawings and HVAC specifications.
Why the Other Options Are Wrong
Option B: Cooling factor multiplier
Cooling factor multiplier is not a standard HVAC term or abbreviation. While cooling factors exist in HVAC calculations, they are not abbreviated as CFM and don't represent a specific measurement unit that would appear on mechanical drawings.
Option C: Condensate flow meter
Condensate flow meter refers to a device that measures water drainage from HVAC equipment, but this is not what CFM represents. Condensate flow would typically be measured in gallons per hour or similar liquid volume units, not cubic feet per minute.
Option D: Central fan motor
Central fan motor describes a component of an HVAC system, not a unit of measurement. While fan motors are crucial for moving air measured in CFM, the abbreviation CFM itself refers to the airflow measurement, not the motor equipment.
Memory Technique
Think 'Cubic Feet Moving' - CFM measures how much air space is moving through the system each minute
Reference Hint
Florida Building Code - Mechanical, Chapter 4 (Ventilation) or HVAC section of construction reference materials
More Project Mgmt Questions
What is the minimum R-value required for wall insulation in Florida Climate Zone 2?
A subcontractor brings a new chemical product to your jobsite. Under the Globally Harmonized System (GHS), what information must be immediately available to workers?
A construction site has a trench that is 8 feet deep in Type B soil. What is the maximum allowable slope ratio for the trench walls without protective systems?
A detail drawing shows a scale of 3/4" = 1'-0". If a dimension measures 2.25 inches on the drawing, what is the actual dimension?
What is the maximum recommended spacing between drywall screws when attaching to wood studs?
People Also Study
Business & Financial Management
120 questions · 70% to pass
Contract Administration
60 questions · 70% to pass
Previous Question
A tower crane is being erected on a construction site. The crane will have a maximum lifting capacity of 12 tons and a boom length of 180 feet. What certification is required before the crane can be used?
Next Question
A Safety Data Sheet (SDS) must be readily accessible to employees within how many minutes of a request?