An electrical panel needs maintenance during construction. The lockout/tagout procedure requires that stored energy be released. What is the maximum voltage allowed for testing equipment during lockout procedures?
Correct Answer
C) No specific limit if proper PPE is used
While OSHA doesn't specify a voltage limit for testing during lockout, proper PPE and safe work practices must be used. Testing may be necessary to verify zero energy state, but must be done safely with appropriate equipment and procedures.
Why This Is the Correct Answer
OSHA's lockout/tagout standard (29 CFR 1910.147) does not establish a specific voltage limit for testing equipment during lockout procedures. The key requirement is that testing must be performed safely using appropriate personal protective equipment and proper procedures. Testing is often necessary to verify that equipment is truly in a zero-energy state, but it must be done by qualified personnel following established safety protocols. The emphasis is on safe work practices rather than arbitrary voltage limits.
Why the Other Options Are Wrong
Option A: 50 volts
50 volts is not an OSHA-established limit for testing during lockout procedures. While this might be considered a relatively safe voltage level, OSHA focuses on proper procedures and PPE rather than setting specific voltage thresholds for testing equipment.
Option B: 120 volts
120 volts is not specified by OSHA as a maximum testing voltage during lockout procedures. This appears to reference standard household voltage, but OSHA's lockout/tagout requirements focus on safe procedures and appropriate PPE rather than voltage limits.
Option D: Testing is prohibited during lockout
Testing is not prohibited during lockout procedures. In fact, testing is often essential to verify that equipment is in a zero-energy state and that the lockout procedure has been effective. The key is that testing must be performed safely by qualified personnel using proper equipment and procedures.
Memory Technique
Think 'PPE over PSI' - Personal Protective Equipment and Proper Procedures are more important than specific voltage limits (PSI as a play on 'pounds per square inch' representing arbitrary numerical limits)
Reference Hint
OSHA 29 CFR 1910.147 - The Control of Hazardous Energy (Lockout/Tagout), particularly sections dealing with testing and verification procedures
More Project Mgmt Questions
What is the minimum R-value required for wall insulation in Florida Climate Zone 2?
A subcontractor brings a new chemical product to your jobsite. Under the Globally Harmonized System (GHS), what information must be immediately available to workers?
A construction site has a trench that is 8 feet deep in Type B soil. What is the maximum allowable slope ratio for the trench walls without protective systems?
A detail drawing shows a scale of 3/4" = 1'-0". If a dimension measures 2.25 inches on the drawing, what is the actual dimension?
What is the maximum recommended spacing between drywall screws when attaching to wood studs?
People Also Study
Business & Financial Management
120 questions · 70% to pass
Contract Administration
60 questions · 70% to pass
Previous Question
You are managing a project where lead paint removal is required. Workers must use respirators, but one worker claims the respirator is uncomfortable and requests to work without it. How should you respond?
Next Question
You are installing a guardrail system on a roof. What is the minimum height requirement for the top rail?