According to the Florida Building Code, what is the minimum door width required for an accessible entrance?
Correct Answer
B) 32 inches
The Florida Building Code requires a minimum clear width of 32 inches for accessible doorways. This measurement is taken with the door open 90 degrees, measured between the face of the door and the opposite stop.
Why This Is the Correct Answer
The Florida Building Code requires a minimum clear width of 32 inches for accessible doorways to comply with ADA standards. This measurement ensures wheelchair users and individuals with mobility devices can pass through comfortably. The 32-inch requirement is measured as clear width when the door is open 90 degrees, between the face of the door and the opposite stop. This standard is consistent with federal accessibility guidelines and is strictly enforced in Florida construction.
Why the Other Options Are Wrong
Option A: 30 inches
30 inches is insufficient for accessibility compliance and does not meet the minimum clear width requirements established by the Florida Building Code for accessible entrances.
Option C: 34 inches
34 inches exceeds the minimum requirement, and while it would be acceptable, it is not the minimum standard specified by the code.
Option D: 36 inches
36 inches exceeds the minimum requirement and while it would provide better accessibility, it is not the minimum standard required by the Florida Building Code.
Memory Technique
Remember '32 for ADA' - the number 32 is the key accessibility door width that appears in most building codes nationwide.
Reference Hint
Florida Building Code, Chapter 11 - Accessibility, Section 1133 (Doors and Doorways) or Florida Accessibility Code for Building Construction
More Project Mgmt Questions
What is the minimum R-value required for wall insulation in Florida Climate Zone 2?
A subcontractor brings a new chemical product to your jobsite. Under the Globally Harmonized System (GHS), what information must be immediately available to workers?
A construction site has a trench that is 8 feet deep in Type B soil. What is the maximum allowable slope ratio for the trench walls without protective systems?
A detail drawing shows a scale of 3/4" = 1'-0". If a dimension measures 2.25 inches on the drawing, what is the actual dimension?
What is the maximum recommended spacing between drywall screws when attaching to wood studs?
People Also Study
Business & Financial Management
120 questions · 70% to pass
Contract Administration
60 questions · 70% to pass