A worker discovers an underground utility vault that needs to be entered for inspection. Before entry, what is the FIRST step that must be taken according to OSHA confined space procedures?
Correct Answer
C) Determine if the space meets the definition of a permit-required confined space
The first step is to evaluate whether the space meets OSHA's definition of a permit-required confined space. This determination drives all subsequent safety procedures and requirements for entry.
Why This Is the Correct Answer
OSHA 29 CFR 1926.95 requires that before any entry procedures begin, employers must first determine whether the space qualifies as a permit-required confined space. This initial classification determines whether a permit is needed and which specific safety protocols must be followed. All other safety measures (atmospheric testing, communication, ventilation) are contingent upon this initial determination. Without this classification step, workers cannot know which level of protection and procedures are required.
Why the Other Options Are Wrong
Option A: Test the atmosphere for oxygen, flammable gases, and toxic substances
While atmospheric testing is critical and required before entry, it comes after determining if the space is permit-required. You cannot establish proper testing protocols without first knowing the classification of the space.
Option B: Establish communication procedures with the attendant
Communication procedures are essential but are established as part of the permit process, which only occurs after determining the space requires a permit. This step comes later in the sequence.
Option D: Set up mechanical ventilation
Mechanical ventilation may be required depending on the space classification and atmospheric conditions, but this determination cannot be made until you first classify the space and assess its hazards.
Memory Technique
Think 'Before you PERMIT entry, you must first DETERMINE if a permit is required.' The word 'permit-required' in the correct answer is your key - you can't get a permit until you know if you need one.
Reference Hint
OSHA Construction Standards 29 CFR 1926.95 - Personal Protective Equipment, and 29 CFR 1910.146 - Permit-Required Confined Spaces (often referenced in construction)
More Project Mgmt Questions
What is the minimum R-value required for wall insulation in Florida Climate Zone 2?
A subcontractor brings a new chemical product to your jobsite. Under the Globally Harmonized System (GHS), what information must be immediately available to workers?
A construction site has a trench that is 8 feet deep in Type B soil. What is the maximum allowable slope ratio for the trench walls without protective systems?
A detail drawing shows a scale of 3/4" = 1'-0". If a dimension measures 2.25 inches on the drawing, what is the actual dimension?
What is the maximum recommended spacing between drywall screws when attaching to wood studs?
People Also Study
Business & Financial Management
120 questions · 70% to pass
Contract Administration
60 questions · 70% to pass
Previous Question
On a detail drawing, what does a section line with the notation 'A/A5.1' typically indicate?
Next Question
A contractor is installing ceramic tile over a concrete slab. The slab has a moisture emission rate of 4.5 pounds per 1,000 square feet per 24 hours. What action should be taken?