An HVAC plan shows a ductwork symbol with 'SA-1' marked inside. What does this designation typically represent?
Correct Answer
A) Supply Air - Zone 1
SA-1 in HVAC drawings typically indicates Supply Air for Zone 1. This helps identify different supply air zones or systems within the building's mechanical design.
Why This Is the Correct Answer
SA-1 is standard HVAC notation where 'SA' stands for Supply Air and the number '1' designates the specific zone or system. This designation appears on ductwork symbols to identify which supply air system the duct belongs to in multi-zone HVAC layouts. The notation helps contractors and technicians distinguish between different air handling systems during installation and maintenance.
Why the Other Options Are Wrong
Option B: Smoke Alarm - Type 1
Smoke alarms are typically designated as 'SD' (Smoke Detector) on plans, not 'SA', and they appear on fire protection or electrical drawings rather than within ductwork symbols on HVAC plans.
Option C: Service Access - Location 1
Service access points would be marked differently, often with 'ACCESS' or 'SA' might refer to service access in other contexts, but when found inside ductwork symbols on HVAC plans, it specifically refers to supply air systems.
Option D: Sound Attenuation - Level 1
Sound attenuation equipment is usually designated with different symbols and abbreviations like 'ATTEN' or specific acoustic symbols, and would not typically use the 'SA' designation within ductwork symbols.
Memory Technique
Remember 'SA' as 'Supply Air' - think 'Supplying Air' to help distinguish it from RA (Return Air) and EA (Exhaust Air) in HVAC drawings.
Reference Hint
Florida Building Code - Mechanical, Chapter 6 (Duct Systems) or ASHRAE standards for HVAC symbols and abbreviations
More Project Mgmt Questions
What is the minimum R-value required for wall insulation in Florida Climate Zone 2?
A subcontractor brings a new chemical product to your jobsite. Under the Globally Harmonized System (GHS), what information must be immediately available to workers?
A construction site has a trench that is 8 feet deep in Type B soil. What is the maximum allowable slope ratio for the trench walls without protective systems?
A detail drawing shows a scale of 3/4" = 1'-0". If a dimension measures 2.25 inches on the drawing, what is the actual dimension?
What is the maximum recommended spacing between drywall screws when attaching to wood studs?
People Also Study
Business & Financial Management
120 questions · 70% to pass
Contract Administration
60 questions · 70% to pass