EstatePass
trade-general-buildingPlumbing BasicsMEDIUM

Under CALGreen requirements, what is the maximum flow rate allowed for new residential bathroom faucets and lavatory faucets in California?

Correct Answer

C) 2.0 gallons per minute (gpm)

CALGreen (California Green Building Standards Code) Section 4.303.1 requires residential bathroom faucets and lavatory faucets to have a maximum flow rate of 2.0 gpm at 60 psi. This water conservation measure is more stringent than federal requirements and helps California meet its water efficiency goals.

Answer Options
A
2.5 gallons per minute (gpm)
B
1.8 gallons per minute (gpm)
C
2.0 gallons per minute (gpm)
D
2.2 gallons per minute (gpm)

Why This Is the Correct Answer

CALGreen (California Green Building Standards Code) Section 4.303.1 requires residential bathroom faucets and lavatory faucets to have a maximum flow rate of 2.0 gpm at 60 psi. This water conservation measure is more stringent than federal requirements and helps California meet its water efficiency goals.

Was this explanation helpful?

More trade-general-building Questions

When installing engineered lumber joists (I-joists) in California residential construction, what is the primary code requirement for web stiffeners?

What is the required attic ventilation ratio when a vapor retarder is installed on the warm-in-winter side of the ceiling according to the California Residential Code?

In California's Wildland-Urban Interface (WUI) areas, which underlayment requirement applies to Class A fire-rated roof assemblies?

In California, when installing a tankless water heater in a seismic zone, what additional requirement must be met beyond standard installation practices?

According to the California Building Code (CBC), what is the minimum lap splice length for #4 rebar in a concrete foundation wall in normal weight concrete with f'c = 3000 psi?

According to CBC requirements for retaining walls in California, what additional design consideration must be addressed for retaining walls over 4 feet in height located in seismic design categories D, E, and F?

When constructing retaining walls in California that exceed 4 feet in height, which CBC requirement must be met regarding drainage?

Under California regulations, when is a reduced pressure principle (RPP) backflow prevention assembly required for a residential water service connection?

Under California Title 24, what is the minimum electrical service size required for new single-family residential construction?

According to the California Building Code, buildings located in Seismic Design Category D must comply with which specific seismic design requirements?

People Also Study

Related Study Resources

Practice More Contractor Exam Questions

Access all practice questions with progress tracking and adaptive difficulty to pass your Florida General Contractor exam.

Start Practicing

Disclaimer: EstatePass is an independent exam preparation platform and is not affiliated with, endorsed by, or connected to any state contractor licensing board, the Construction Industry Licensing Board (CILB), the Department of Business and Professional Regulation (DBPR), NASCLA, Pearson VUE, PSI, or any government agency. Exam requirements, fees, and regulations change frequently. Always verify current requirements with your state's licensing board before making decisions. Information shown was last verified on the dates indicated and may not reflect the most recent changes.