On mechanical drawings, what does the abbreviation 'CFM' represent?
Correct Answer
D) Cubic feet per minute
CFM stands for Cubic Feet per Minute, which is a standard unit of measurement for airflow in HVAC systems. This measurement is critical for proper system sizing and performance.
Why This Is the Correct Answer
CFM stands for Cubic Feet per Minute, which is the standard unit of measurement for airflow volume in HVAC and mechanical systems. This measurement indicates how many cubic feet of air pass through a given point in one minute. It's essential for sizing ductwork, fans, and ventilation equipment to ensure proper air circulation and system performance in buildings.
Why the Other Options Are Wrong
Option A: Central fan motor
This option incorrectly combines cubic feet (an imperial volume unit) with meters (a metric length unit). This mixed unit system doesn't exist in standard engineering practice. Proper airflow measurements use consistent unit systems - either all imperial or all metric.
Option C: Cubic feet per meter
While this sounds technical, 'Compressed fluid measurement' is not a standard engineering abbreviation or term. CFM specifically refers to airflow volume rate, not a general fluid measurement system. This option creates confusion by using vague terminology that doesn't correspond to actual mechanical engineering standards.
More Project Mgmt Questions
What is the minimum R-value required for wall insulation in Florida Climate Zone 2?
A subcontractor brings a new chemical product to your jobsite. Under the Globally Harmonized System (GHS), what information must be immediately available to workers?
A construction site has a trench that is 8 feet deep in Type B soil. What is the maximum allowable slope ratio for the trench walls without protective systems?
What is the maximum recommended spacing between drywall screws when attaching to wood studs?
Your crew discovers suspected asbestos-containing materials during a renovation project. What is the first action you should take?
A scaffold platform is 12 feet long and 5 feet wide. If the maximum load capacity is 25 pounds per square foot, what is the total weight capacity of this platform?
Which CSI MasterFormat Division would contain specifications for fire-stopping and firesafing materials?
In tilt-up concrete construction, what is the primary advantage of this method over conventional cast-in-place construction?
Which OSHA standard specifically addresses construction industry safety and health regulations?
A structural drawing shows a beam labeled 'W12x26'. What does the '26' represent?
People Also Study
Business & Financial Management
120 questions · 70% to pass
Contract Administration
60 questions · 70% to pass