In California seismic design categories D1 and D2, what is the required connection between the sill plate and foundation for wood-framed construction?
Correct Answer
C) 1/2-inch diameter anchor bolts at 6 feet on center maximum
According to CRC Section R403.1.6 and California's seismic provisions, anchor bolts must be minimum 1/2-inch diameter and spaced no more than 6 feet on center in seismic design categories D1 and D2. This ensures adequate connection between the wood frame and foundation to resist seismic forces.
Why This Is the Correct Answer
According to CRC Section R403.1.6 and California's seismic provisions, anchor bolts must be minimum 1/2-inch diameter and spaced no more than 6 feet on center in seismic design categories D1 and D2. This ensures adequate connection between the wood frame and foundation to resist seismic forces.
More trade-general-building Questions
When installing engineered lumber joists (I-joists) in California residential construction, what is the primary code requirement for web stiffeners?
What is the required attic ventilation ratio when a vapor retarder is installed on the warm-in-winter side of the ceiling according to the California Residential Code?
In California's Wildland-Urban Interface (WUI) areas, which underlayment requirement applies to Class A fire-rated roof assemblies?
In California, when installing a tankless water heater in a seismic zone, what additional requirement must be met beyond standard installation practices?
According to the California Building Code (CBC), what is the minimum lap splice length for #4 rebar in a concrete foundation wall in normal weight concrete with f'c = 3000 psi?
According to CBC requirements for retaining walls in California, what additional design consideration must be addressed for retaining walls over 4 feet in height located in seismic design categories D, E, and F?
When constructing retaining walls in California that exceed 4 feet in height, which CBC requirement must be met regarding drainage?
Under California regulations, when is a reduced pressure principle (RPP) backflow prevention assembly required for a residential water service connection?
Under California Title 24, what is the minimum electrical service size required for new single-family residential construction?
According to the California Building Code, buildings located in Seismic Design Category D must comply with which specific seismic design requirements?
People Also Study
Business & Financial Management
120 questions · 70% to pass
Contract Administration
60 questions · 70% to pass
Project Management
60 questions · 70% to pass
Related Study Resources
Previous Question
According to the California Plumbing Code, what is the minimum size vent pipe required for a residential building drain serving a 3-inch building drain?
Next Question
In California seismic design, buildings located in Seismic Design Category D must comply with which additional requirement compared to lower seismic categories?