In California residential construction, what is the minimum bearing length required for floor joists bearing on wood sill plates or beams?
Correct Answer
C) 1.5 inches
CRC Section R502.6 specifies a minimum bearing length of 1.5 inches for floor joists on wood sill plates or beams. This ensures adequate load transfer and prevents crushing of the bearing surface under load conditions typical in California construction.
Why This Is the Correct Answer
CRC Section R502.6 specifies a minimum bearing length of 1.5 inches for floor joists on wood sill plates or beams. This ensures adequate load transfer and prevents crushing of the bearing surface under load conditions typical in California construction.
More trade-general-building Questions
When installing engineered lumber joists (I-joists) in California residential construction, what is the primary code requirement for web stiffeners?
What is the required attic ventilation ratio when a vapor retarder is installed on the warm-in-winter side of the ceiling according to the California Residential Code?
In California's Wildland-Urban Interface (WUI) areas, which underlayment requirement applies to Class A fire-rated roof assemblies?
In California, when installing a tankless water heater in a seismic zone, what additional requirement must be met beyond standard installation practices?
According to the California Building Code (CBC), what is the minimum lap splice length for #4 rebar in a concrete foundation wall in normal weight concrete with f'c = 3000 psi?
According to CBC requirements for retaining walls in California, what additional design consideration must be addressed for retaining walls over 4 feet in height located in seismic design categories D, E, and F?
When constructing retaining walls in California that exceed 4 feet in height, which CBC requirement must be met regarding drainage?
Under California regulations, when is a reduced pressure principle (RPP) backflow prevention assembly required for a residential water service connection?
Under California Title 24, what is the minimum electrical service size required for new single-family residential construction?
According to the California Building Code, buildings located in Seismic Design Category D must comply with which specific seismic design requirements?
People Also Study
Business & Financial Management
120 questions · 70% to pass
Contract Administration
60 questions · 70% to pass
Project Management
60 questions · 70% to pass
Related Study Resources
Previous Question
What is the required net free ventilation area ratio for attic spaces when both intake and exhaust ventilation are provided according to the California Residential Code?
Next Question
Under California's Title 24 Building Energy Efficiency Standards, what is required for solar-ready electrical installations in new single-family homes?