According to the California Electrical Code, GFCI protection is required for all 125-volt, single-phase, 15- and 20-ampere receptacles installed in which residential location?
Correct Answer
A) Garages and accessory buildings
The California Electrical Code (CEC) Article 210.8(A) requires GFCI protection for receptacles in garages and accessory buildings at grade level. This protection is mandatory due to the increased risk of ground faults in these potentially damp locations with concrete floors.
Why This Is the Correct Answer
The California Electrical Code (CEC) Article 210.8(A) requires GFCI protection for receptacles in garages and accessory buildings at grade level. This protection is mandatory due to the increased risk of ground faults in these potentially damp locations with concrete floors.
More trade-general-building Questions
When installing engineered lumber joists (I-joists) in California residential construction, what is the primary code requirement for web stiffeners?
What is the required attic ventilation ratio when a vapor retarder is installed on the warm-in-winter side of the ceiling according to the California Residential Code?
In California's Wildland-Urban Interface (WUI) areas, which underlayment requirement applies to Class A fire-rated roof assemblies?
In California, when installing a tankless water heater in a seismic zone, what additional requirement must be met beyond standard installation practices?
According to the California Building Code (CBC), what is the minimum lap splice length for #4 rebar in a concrete foundation wall in normal weight concrete with f'c = 3000 psi?
According to CBC requirements for retaining walls in California, what additional design consideration must be addressed for retaining walls over 4 feet in height located in seismic design categories D, E, and F?
When constructing retaining walls in California that exceed 4 feet in height, which CBC requirement must be met regarding drainage?
Under California regulations, when is a reduced pressure principle (RPP) backflow prevention assembly required for a residential water service connection?
Under California Title 24, what is the minimum electrical service size required for new single-family residential construction?
According to the California Building Code, buildings located in Seismic Design Category D must comply with which specific seismic design requirements?
People Also Study
Business & Financial Management
120 questions · 70% to pass
Contract Administration
60 questions · 70% to pass
Project Management
60 questions · 70% to pass
Related Study Resources
Previous Question
According to California Title 24 Part 6 Energy Standards, what is the minimum R-value requirement for wall insulation in Climate Zone 3?
Next Question
Under CBC Chapter 16, buildings assigned to Seismic Design Category D must comply with which additional seismic design requirements beyond those for Category C?