According to OSHA 29 CFR 1926.501, at what height must fall protection be provided for employees working on unprotected sides and edges?
Correct Answer
B) 6 feet
OSHA requires fall protection for employees working on unprotected sides and edges at 6 feet or more above a lower level. This is the standard trigger height for fall protection in construction.
Why This Is the Correct Answer
OSHA 29 CFR 1926.501(b)(1) specifically states that employees working on unprotected sides and edges must have fall protection when they are 6 feet or more above a lower level. This is the fundamental trigger height established by OSHA for construction work. The 6-foot rule is consistently applied across most construction activities including walking/working surfaces, holes, and leading edges. This standard recognizes that falls from 6 feet or higher pose significant risk of serious injury or death to workers.
Why the Other Options Are Wrong
Option A: 4 feet
10 feet is far too high and would expose workers to unnecessary risk in the 6-10 foot range, contradicting OSHA's protective intent
Option C: 8 feet
4 feet is too low and does not meet OSHA's established safety threshold for construction work, though it may apply in some specific industrial settings under different regulations
Option D: 10 feet
8 feet exceeds the OSHA requirement and would leave workers unprotected in the dangerous 6-8 foot range where serious injuries commonly occur
Memory Technique
Think 'Six feet, safety net' - the alliteration helps remember that 6 feet is when fall protection kicks in
Reference Hint
OSHA 29 CFR 1926.501(b)(1) - Subpart M Fall Protection, or Florida Building Code Chapter 15 Safety Requirements
More Project Mgmt Questions
What is the minimum R-value required for wall insulation in Florida Climate Zone 2?
A subcontractor brings a new chemical product to your jobsite. Under the Globally Harmonized System (GHS), what information must be immediately available to workers?
A construction site has a trench that is 8 feet deep in Type B soil. What is the maximum allowable slope ratio for the trench walls without protective systems?
What is the maximum recommended spacing between drywall screws when attaching to wood studs?
Your crew discovers suspected asbestos-containing materials during a renovation project. What is the first action you should take?
A scaffold platform is 12 feet long and 5 feet wide. If the maximum load capacity is 25 pounds per square foot, what is the total weight capacity of this platform?
Which CSI MasterFormat Division would contain specifications for fire-stopping and firesafing materials?
In tilt-up concrete construction, what is the primary advantage of this method over conventional cast-in-place construction?
Which OSHA standard specifically addresses construction industry safety and health regulations?
A structural drawing shows a beam labeled 'W12x26'. What does the '26' represent?
People Also Study
Business & Financial Management
120 questions · 70% to pass
Contract Administration
60 questions · 70% to pass