According to OSHA 29 CFR 1926.501, at what height must fall protection be provided for employees working on walking/working surfaces with unprotected sides and edges?
Correct Answer
C) 6 feet
OSHA requires fall protection when employees are working at heights of 6 feet or more above a lower level. This is the standard trigger height for most construction activities.
Why This Is the Correct Answer
According to OSHA 29 CFR 1926.501(b)(1), fall protection is required when employees are working on walking/working surfaces with unprotected sides and edges that are 6 feet or more above the lower level. This 6-foot trigger height is the fundamental standard for most construction activities and applies to general industry construction work where employees could fall to a lower level.
Why the Other Options Are Wrong
Option A: 8 feet
8 feet is incorrect and exceeds the OSHA standard. Using this height would leave workers unprotected in the 6-8 foot range, violating safety regulations and potentially resulting in citations and increased injury risk.
Option B: 4 feet
4 feet is below the OSHA standard and would require unnecessary fall protection equipment and procedures. While some specific activities have lower trigger heights, the general standard for walking/working surfaces is 6 feet.
Option D: 10 feet
10 feet significantly exceeds the OSHA requirement and would leave workers dangerously unprotected. This height might be confused with other safety standards but does not apply to general fall protection requirements.
Memory Technique
Remember 'Six Feet Safe' - OSHA's standard 6-foot trigger height protects workers from serious falls while being practical for construction operations.
More Project Mgmt Questions
What is the minimum R-value required for wall insulation in Florida Climate Zone 2?
A subcontractor brings a new chemical product to your jobsite. Under the Globally Harmonized System (GHS), what information must be immediately available to workers?
A construction site has a trench that is 8 feet deep in Type B soil. What is the maximum allowable slope ratio for the trench walls without protective systems?
What is the maximum recommended spacing between drywall screws when attaching to wood studs?
Your crew discovers suspected asbestos-containing materials during a renovation project. What is the first action you should take?
A scaffold platform is 12 feet long and 5 feet wide. If the maximum load capacity is 25 pounds per square foot, what is the total weight capacity of this platform?
Which CSI MasterFormat Division would contain specifications for fire-stopping and firesafing materials?
In tilt-up concrete construction, what is the primary advantage of this method over conventional cast-in-place construction?
Which OSHA standard specifically addresses construction industry safety and health regulations?
A structural drawing shows a beam labeled 'W12x26'. What does the '26' represent?
People Also Study
Business & Financial Management
120 questions · 70% to pass
Contract Administration
60 questions · 70% to pass